OUTSTANDING PERFORMANCE OF WEIR FRAC PUMP IN ALBERTA
Fort Worth, Texas-based Weir Oil & Gas, one of the world’s largest suppliers of pressure pumping equipment to the upstream market, announced its SPM QEM 3000 Frac Pump continues to yield unsurpassed results and savings in the field as it looks and performs like new after 3,200 hours of field-proven use in extreme conditions in the winter months in the Duvernay and Montney Shale Play in Alberta Canada.
Whatever conditions an operator is running legacy pumps in today, the SPM QEM 3000 can run in similar conditions. Part of the company’s performance line of pumps, the SPM QEM 3000 is expected to extend maintenance cycles by a factor of three as compared to what operators are achieving in similar service conditions currently. These enhancements dramatically affect their bottom lines, expanding traditional frac pump life span to improve uptime and productivity while reducing maintenance costs and total cost of ownership by at least 17 percent.
The SPM QEM 3000 pump is an industry first and only gold standard, as it was purpose-built from the ground up and designed to withstand even the most punishing pressure pumping operations, including continuous duty, at a sustained maximum 275,000-pound rod load. In the Duvernay and Montney formations, the SPM QEM 3000 pump operated 16-18 hours per day in temperatures averaging 20 to 23 degrees Fahrenheit at a frac pressure of 10,500 to 13,000 psi, average rod load of 206,250 to 233,750 psi with a five-inch plunger and a flow rate of 264 gpm to 343gpm.
Roller bearings looked like new after 3,200-hours and shell bearings had considerable life remaining. Other wear parts that would normally require replacement, such as guide sleeves, showed insignificant wear and did not require replacement. Moreover, Weir’s industry-first onboard filtration system delivered clean oil to enhance bearing life through optimized control.
While the traditional frac pump development process typically tests up to one million cycles, Weir completed an endurance test of its beta SPM QEM 3000 in its Fort Worth Research & Development Center lasting three times longer than other pumps in the company’s history. A Calgary, Alberta-based customer is currently operating SPM QEM 3000 pumps that have completed more than 10 million field cycles (approximately 1,700 hours) without any signs of fatigue to the main components at production sites throughout Western Canada. (Source and image: WEIR)
- EXXONMOBIL REPORTS NEW OIL FIND ON THE STABROEK BLOCK OFFSHORE GUYANA 16th September 2019
- AIRBUS HELICOPTERS FINDS ROOT CAUSE OF THE TUROY H225 CRASH 14th September 2019
- LAUNCH OF THE GIANT ARCTIC LNG 2 DEVELOPMENT APPROVED 09th September 2019
- EXXONMOBIL TO LEAVE NORWAY FOR GOOD – THE END OF A BEAUTIFUL STORY 08th September 2019
- NORTH SEA GIANT JOHAN SVERDRUP ON STREAM IN OCTOBER 06th September 2019